Boom length & angle Calculator

Estimate boom geometry from the hook position and manufacturer dimensions.

How to use this calculator

Enter the planned hook radius and hook height, both referenced to the crane's rotation axis and the same vertical datum. Supply the boom pivot's horizontal offset from that axis and its height. Add the vertical headroom from the hook to the top rope lead or sheave point.

If the rope lead differs from the straight boom-axis endpoint, enter its horizontal and vertical head offsets. Positive offsets place the rope lead toward the load and above that endpoint. Use manufacturer dimensions for the actual configuration.

Enter project-specific values in the form below. Blank or out-of-range inputs stop the calculation. Reset restores an illustrative example, not verified project data. Keep the input sources, assumptions and worked calculation with the result when exporting the PDF.

Formula and assumptions

x = hook radius − pivot horizontal offset − head horizontal offset. z = hook height + headroom − pivot height − head vertical offset. B = √(x² + z²). β = atan2(z, x).

B is the straight distance from the boom pivot to the defined boom-axis endpoint, and β is its geometric angle from horizontal. The model requires a positive forward horizontal reach and positive vertical rise.

This is a straight-axis geometry estimate, not a manufacturer's nominal boom length, telescoping selection or rated capacity. It does not resolve boom deflection, jib geometry, offsets that rotate with the boom, reeving, load chart limits, obstacle clearances or crane stability. Enter offsets projected onto the calculation's horizontal and vertical axes.

Worked example

Forward reach x: 10 m; rise z: 18 m; straight-axis boom geometry: 20.59126 m; angle from horizontal: 60.945396°.

Illustrative values only. This example is not equipment selection or a recommended operating arrangement.

Example values only. Replace with verified project data.

AI concept: Industrial lifting equipment

CALCULATION OUTPUT

Method & assumptions

Reference / background ↗
AI concept: Planning desk

Take the calculation with you.

Discuss on WhatsApp ↗

Before using the result

Reconcile the geometric estimate with the manufacturer's boom dimensions, pivot and sheave positions, available lengths and load chart for the actual configuration. Confirm operating radius under load, deflection, reeving, load clearance and ground conditions separately. This estimate cannot establish a permissible crane selection.

Continue planning

Related tools: sling length and vertical rise · crane chart utilisation · pad bearing pressure.

Planning information, not lift approval. Confirm applicable Malaysian and project requirements with the responsible parties. No appointment or booking is made automatically.

Engineering method and standards basis

The numeric equations are engineering geometry or an average-pressure model. They are not a certification of compliance or DOSH approval. No standard clause is asserted as the source of this straight-axis geometry. Manufacturer dimensions, rated capacity charts and configuration limits remain necessary.

Check the edition and clauses required by the project. These sources belong to the requested standards families. A publisher listing alone does not establish that a particular calculation is compliant.

Discuss your lift