Tagline length Calculator

Plan the geometric rope span and record your own allowance.

How to use this calculator

Enter the load attachment height and the handler's hand height from the same datum, then the positive horizontal distance between them. Add any extra rope allowance as an explicit project input. The result is the straight geometric span plus that allowance.

Assess the handler position and the whole load path separately. This calculation does not determine a safe stand-off distance, control force, rope rating or a universal minimum length.

Enter project-specific values in the form below. Blank or out-of-range inputs stop the calculation. Reset restores an illustrative example, not verified project data. Keep the input sources, assumptions and worked calculation with the result when exporting the PDF.

Formula and assumptions

ΔH = attachment height − hand height. L_straight = √(ΔH² + D²). L_total = L_straight + allowance. α = atan2(|ΔH|, D).

D is the positive horizontal separation. α is the acute rope angle from horizontal; the signed height difference identifies whether the attachment is above or below the hand. The allowance is user-entered and non-negative. No fixed extra allowance is added automatically.

Uses a straight line between the two points. Sag, stretch, knots, grip length, load motion, wind, snags, rope force and the safe handler position are not resolved. Tagline use and length must suit the lift plan and changing geometry throughout the lift.

Worked example

Height difference: 7 m; straight geometric span: 12.206556 m; rope length including entered allowance: 14.206556 m; acute angle from horizontal: 34.99202°.

Illustrative values only. This example is not equipment selection or a recommended operating arrangement.

Example values only. Replace with verified project data.

AI concept: Industrial lifting equipment

CALCULATION OUTPUT

Method & assumptions

Reference / background ↗
AI concept: Planning desk

Take the calculation with you.

Discuss on WhatsApp ↗

Before using the result

Review the full lift path, exclusion zone, line routing, handler escape route and possible snag or entanglement points. The entered horizontal distance is not a calculated safe position. Confirm the rope, its use and the required control with the responsible lift planner.

Continue planning

Related tools: boom geometry · two- and four-leg sling geometry.

Planning information, not lift approval. Confirm applicable Malaysian and project requirements with the responsible parties. No appointment or booking is made automatically.

Engineering method and standards basis

The numeric equations are engineering geometry or an average-pressure model. They are not a certification of compliance or DOSH approval. ASME B30.5-2018 §5-3.1.3.4(h) calls for taglines when additional load control is required. It does not prescribe a universal tagline length, extra allowance, rope diameter or safe handler position.

Check the edition and clauses required by the project. These sources belong to the requested standards families. A publisher listing alone does not establish that a particular calculation is compliant.

Discuss your lift