Tools/Excavator Lift Planner

EXCAVATOR LIFT PLANNER

CHECK THE CHART.
CONTROL THE LOAD.

Match the exact excavator, lifting point and setup. Account for attachments once. Keep the evidence with your plan.

This tool compares an entered manufacturer chart and a rated lifting point for a stationary excavator on firm level support with a vertical suspended load. No OEM capacity is supplied. Confirm that the manufacturer permits object handling with the exact machine and setup.

MACHINE CATALOGUE

Choose your excavator.

Model names are a searchable catalogue. They do not supply machine specifications, chart capacities, attachment ratings or object-handling permission. Use Custom for any unlisted machine or exact suffix.

ARTICULATED LIFT GEOMETRY

One lifting point. One clear layout.

SCHEMATIC

Adjust boom, arm & bucket

Illustration controls ready
Positive curl folds toward the machine; negative curl dumps out.
Adjust lengths, sizes & offsets

The generic body and linkage are simplified. Enter boom pin length, arm-to-lifting-point length, boom-foot offset and height, actual lift radius and height. The elbow-up solution connects those inputs. Bucket linkage offsets and OEM reach envelopes require separate verification. Below-grade lift heights are allowed; soil and trench geometry are not shown. Sliders stage a drawing before you apply it to the plan. Camera changes only change the view. Bucket shape and curl are illustrative; they do not define attachment mass or a rated lifting point.

Excavator drawing reference

The simplified body follows the proportions of a 20-tonne Komatsu PC200 reference. Entered undercarriage dimensions scale the outline; cabin details, cylinder mounts and connectors remain illustrative. The bucket can be shown, hidden, resized and curled independently of the entered lift point. Its appearance does not establish bucket or coupler mass, lifting suitability or WLL. The illustrated arm-end connector remains the entered reference point; reconcile it with the actual rated hook using the position source. Verify the actual lifting point, attachment and machine configuration.

Komatsu PC200-10M0 · official brochure and dimensional drawing

01

Plan record

02

Machine & retained attachments

Record boom, arm, counterweight, bucket / coupler and the actual track, tyre, blade or stabiliser setup. A retained bucket / coupler affects the machine chart comparison. It is separate from gear hanging below the lifting point.

03

Load & rated lifting point

Enter payload and every sling, shackle and lifting accessory below the lifting point once. The point height is the height used by the selected OEM chart, not the top of the payload. The chart reference point and the actual rated hook must be reconciled in the position source.

04

OEM chart & attachment accounting

Use the capacity for the exact radius, signed point height, sector and machine setup. If the entered capacity already deducts part of the retained attachment mass, record that allowance below. Payload and hanging rigging cannot be entered as already-deducted attachments. OEM tipping / hydraulic rating percentages are already built into the chart; do not apply them again automatically.

05

Drawing geometry

These dimensions drive the drawing and do not generate a load chart. Body proportions remain generic. A drawing can be incomplete while a separately verified chart comparison is recorded. Bucket dimensions and curl control its appearance only. Record the actual retained attachment mass in Machine & retained attachments; no mass or rating is inferred from the drawing.

06

Site method & controls

PDF document details

07

Demand. Ratings. Evidence.

Chart notes & manufacturer references

This is a local editable planning record with PDF export. It does not create an online approval or inspection record. Missing planning controls remain visible in the report.

Excavator lift plan PDF

Open PDF in a new tab ↗

Discuss your lift